Run-time parameters

Reading time ~2 minutes

Use the "Run-time parameters" tab to view the default Cinegy Archive Service run-time settings or to change the existing ones:

run_time

  • Port – the port number used by the Cinegy Archive Service. Increase or decrease the value by pressing the Arrow up button or Arrow down button buttons respectively, or entering the desired value via the keyboard.

    Note
    		 The port used by the Cinegy Archive Service should be open in the Firewall (the default port is 8082).

  • Duplicate login behavior – define the Cinegy Archive Service behavior on an attempt at concurrent connection to the Cinegy Archive Service by the same user. You can choose the following options from the drop-down list:

    duplicate_login_behavior

    • Allow – multiple connections to the Cinegy Archive Service under the same user are allowed.

    • Refuse – the concurrent connection to the Cinegy Archive Service under the same user will be refused.

    • Replace – the active connection will be replaced by the new one under the same user, and the disconnected user will be informed about it with the corresponding message.

  • Time of inactivity – time in seconds, while the user is considered as connected to the Cinegy Archive Service (in case the idle time does not exceed a specified value). The default inactivity time value is 3600 seconds, but you can change it by pressing the Arrow up button or Arrow down button button respectively, or entering the desired value via the keyboard.

  • Use cache – leave the "Use cache" option selected to use the internal cache.